Piega SUB 1 MKII User Manual download pdf (Page 13)

Thanks to the use of the most advanced active electronics, your new PIEGA P SUB 1 MKII is a cutting edge product in the eld of

subwoofers. Thanks to the variable „HP Filter Q“ it features the ability to simulate an unlimited range of sound characteristics. This

enables you to adjust operation within the deep bass range to your individual audio requirements, as well as to those of the listening

environment.

PIEGA P SUB 1 MKII

Setting options for individual requirements...

Settings of the Sound Characteristics

VOLUME

>Use this knob to adjust the subwoofer volume

Setting tip: Turn the subwoofer to maximum volume and then turn it

down until it sounds too quiet for you

PHASE-SWITCH

>Use this switch to set the subwoofer to In Phase or Out of Phase.

Depending on the type of loudspeaker, there will be a phase cancelling

(little bass) or a phase correction (normal bass)

>>Factory setting 0

PHASE-SHIFT

>Use this knob to adjust the phase to your system

>>Factory setting 0

SUBSONIC

>Use this selector switch to activate the SUBSONIC lter. This is used to

lter out frequencies below 15 Hz and thus relieve the subwoofer of

inaudible frequencies

>>Factory setting OFF

FILTER-Q

>Use this knob to set the lter quality in the range between 0.5 to 0.8 -

Turning the knob clockwise will cause a dry, clean and very precise

bass, turning the knob anti-clockwise will produce a warm and more

mellow bass

CROSSOVER-FREQUENCY

>This knob is used for adjusting the crossover frequency between

subwoofer and full-range speaker

>>Factory setting 80 – 100 Hz

VOLUME

MIN. MAX.

PHASE-SHIFT

1800

PHASE-SWITCH

OFFON

SUBSONIC

FILTER-Q

60Hz

140Hz40Hz

CROSSOVER

FREQUENCY

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Piega SUB 1 MKII User Manual Page 13

Comments to this Manuals

Related products and manuals for Supplementary music equipment Piega SUB 1 MKII